Changing a wheel on your Citroen C4 Picasso 2

Knowing how to replace is not a really difficult task to achieve, but you must know the different phases to follow. Sometimes this will save you a lot of hassle in a complicated situation. In this article, we will show you little by little each step to follow in order to change a wheel on a Citroen C4 Picasso 2 correctly.
First, it is advisable to put on your yellow vest if you are on the side of the road, and also to position your warning triangle about 25-30 meters before your Citroen C4 Picasso 2. Also remember to turn on your warnings.

Steps to replace a wheel on a Citroen C4 Picasso 2:

Here are all the steps to change a wheel on your Citroen C4 Picasso 2:

1: First of all, make sure that your Citroen C4 Picasso 2 is on a adequate soil before you start changing the wheel. This means that it should ideally position your Citroen C4 Picasso 2 on a ground solid and flat. If you don’t have an option as to the firmness of the ground, try to find something to stabilize your automobile, bricks or boards may be effective. In this case, pay close attention to the stability of your Citroen C4 Picasso 2, do not take any risks. Also think about apply the handbrake.
2: To raise the car fitted with the jack up, and thus change the wheel of your Citroen C4 Picasso 2, you will first have to remove the hub cap and slightly unscrew the bolts. Turn them counterclockwise. Do not remove them just loosen them, using the material you have in the boot of your Citroen C4 Picasso 2 with the spare tire. Normally you should have a cross or a release key.
3: From now on, you must position the jack in order to raise your Citroen C4 Picasso 2 a few centimeters. Try to place it close to the wheel to be replaced. Small warning however, your jack must be absolutely stable. Now use the jack to lift your car. Remember to lift until this wheel is no longer in contact with the ground, add a few centimeters if you change a punctured wheel because a new wheel will be larger.
4: When you have your wheel in the air, it is time to completely remove the bolts. Once done, you can remove the wheel to be replaced. Then position the new wheel instead. You can screw the bolts back in, only by hand. Once the wheel is positioned on the ground, you will screw it back in. Do not apply too much force, you risk damaging them.
5: When you have everything tightened, you can put your Citroen C4 Picasso 2 back on the ground. Do this with care, be careful. Now that the car is on the ground, you can tighten the bolts using the hardware. Also, do not over tighten.
6: You can now screw the hubcap back on and store all your equipment in your trunk, your Citroen C4 Picasso 2 is now ready to go.

Conclusion of the wheel change on your Citroen C4 Picasso 2:

You can therefore observe that it is relatively easy to change a wheel. Just be careful to set the scene correctly (beacon, vest, etc.) and position your Citroen C4 Picasso 2 in the best conditions. Also for the jack, really make sure it is secure, and at no time for any reason should you stay under the car. It may be possible for the jack to fail at any time, so be careful.

Adblock
detector